Growatt SPH6000

[MaartenGoris]

Hi,

I just tested the JK-BMSToPylontechCAN on my growatt SPH6000 and it works lika a charm :-)
Thank you for making an sharing this project this saved me a lot off time and stress.

I already had a battery and used the easun inverters, as they are not allowed in belgium i purchased a new Growatt inverter
and there the problems started until i found this project.

Again thanks!!

[ArminJo]

Thanks for the feedback 👍.
If you send one or more pictures of your board, then I can publish them.

[MaartenGoris]

Hi, This is still the test setup, I bought the MCP2515 directly with the 16 Mhz crystal. https://secure.reichelt.com/be/en/developer-boards-can-module-mcp2515-mcp2562-debo-can-modul-p239277.html?&trstct=pos_0&nbc=1 Here i had to put the VCC and VCC1 pin to 5 V (for arduino) for RPI VCC1 should be on 3.3V and VCC on 5V I'm planning to make the code buildable for ESP32 so there is wifi connection and I am able to publish on a MQTT server. Wou you allow me to contribute this to the project? [image: WhatsApp Image 2023-09-14 at 13.47.43.jpeg][image: WhatsApp Image 2023-09-14 at 13.47.43 (6).jpeg][image: WhatsApp Image 2023-09-14 at 13.47.43 (5).jpeg][image: WhatsApp Image 2023-09-14 at 13.47.43 (4).jpeg][image: WhatsApp Image 2023-09-14 at 13.47.43 (3).jpeg][image: WhatsApp Image 2023-09-14 at 13.47.43 (2).jpeg][image: WhatsApp Image 2023-09-14 at 13.47.43 (1).jpeg] Op do 14 sep 2023 om 13:34 schreef Armin ***@***.***>:

…

Thanks for the feedback 👍. If you send one or more pictures of your board, then I can publish them. — Reply to this email directly, view it on GitHub <#10 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AKG2AYALC73USQIYRULIY5TX2LTU3ANCNFSM6AAAAAA4X4PXCM> . You are receiving this because you authored the thread.Message ID: ***@***.*** com>

-- Met vriendelijke groet/Best regards Maarten Goris EnDeGo BV BE0685821969 Automation Engineer Zwaluwenlei 24, 2650 Edegem Phone +32 483 52 07 91 ***@***.*** www.endego.be

[ArminJo]

There already is an esphome version with https://github.com/syssi/esphome-jk-bms.

The pictures do not show up on Github 😞