Blueprint for Heatpump (both Pge6 and Pge9) are not working HA 2023.6.x

[austwhite]

Hi,
It seems the blueprint for the Heatpump control, both Page 6 and Page 9 versions fail in HA 2023.6.x. Well, at least for me it does.
The automation will run initially and the page display on the HASPOne device. I can then press Heat and change the temperature, but when I hit Off it completely freezes up and never runs the automation again. I can delete and recreate the automation, and Home Assistant reports it is never running. If I wait several hours, then it might run again, but the same thing as above happens. It will stop running when the Off button is used and then the automation stops running again
This happens with both the Page 6 and Page 9 versions.

This is not a critical thing, as I can use different options to control HVAC systems, it would just be a nice to have on the HASPOne :)

Thanks :)

[austwhite]

As an additional comment. The issue seems to happen when "off" is selected and the automation doesn't run when the HVAC is in "off" mode" . If I set the HVAC to Heat or Cool mode, then the automation resumes running and I can control everything from the HASPOne. As soon as the HVAC is switched to OFF, the automation stops running again.
Happens with both Pge6 and Pge9 versions, so looks to be something when climate.xxxx is in the "off" mode.

[BenJewell]

Did you ever find a solution for this?

[austwhite]

No soloution found for this. Will have to wait for th developer to look at it I think.