How do I connect to the Induction Matrix?

[IBuildVans]

Hello! Loving the program so far. I setup a test reactor/turbine and would like to add the Induction Matrix. Ive tried connecting to the RTU/Supervisor/Coordinator and I cannot get it to show as connected. I am using a wired modem connected to an Induction Matrix port. Anyone have any suggestions?

[MikaylaFischler]

So that would need a wired modem connecting the induction matrix to an RTU, then the RTU config (rtu/config.lua on the computer) would need a definition like this in the RTU_DEVICES table (example for if the device connects to the network as inductionPort_0:

    {
        name = "inductionPort_0",
        index = 1,
        for_reactor = 0
    }

[IBuildVans]

Thank you very much for the answer! I was close. I had everything connected. I just still had a 1 when it should have been "for_reactor = 0". I had to wait unntil I was home from work to try it out. Thank you again.

[MikaylaFischler]

Happy to help!

[Overhandmite]

So I tried what you posted here and it crashes my rtu as it says the line was expected to end? I’ve gotten everything else hooked up fine but the induction matrix

[PepijnTrampe]

make sure that you have a comma at one line like
{ name = "boilerValve_0", index = 1, for_reactor = 1 }, { name = "turbineValve_0", index = 1, for_reactor = 1 }, { name = "inductionPort_0", index = 1, for_reactor = 0 } }
if you have 3 divices the first 2 have a comma to close the loop and the last one not atherwise you got a line error