Replies: 2 comments 2 replies
-
|
Can you show how you set these on the physical device - is via the boiler, thermostat? If we haven't yet implemented it, we would need the data which is difficult since you're not on site to capture the telegrams real-time. An alternative is to use the Scheduler in EMS-ESP to turn things on/off at set periods. |
Beta Was this translation helpful? Give feedback.
-
|
The setting is made on the touchscreen of the hot water heater display in the menu. I can take photos of the page structure. |
Beta Was this translation helpful? Give feedback.
-
|
any chance to capture some images? |
Beta Was this translation helpful? Give feedback.
-
|
I can´t update the new version of the latest 3.70 Version, because of this |
Beta Was this translation helpful? Give feedback.
-
Hey guys,
So far I've only read here and I'm impressed.
Since I haven't found a solution yet, I would like to try something out as a beginner, although I don't know whether my research is enough.
I have no knowledge of heating and/or controls, but I look after our clubhouse 100 km away fromm y home, so I installed the EMS-ESP gateway.
Since 11/23 we use a Bosch Condens 7800 iW; UI800/BC400 and EMS-ESP Gateway (EMS-ESP Version 3.6.5)
Since 04/24 we use a 17 m2 Solar thermal collector with 750 liter buffer storage with the following Bosch controls MM100, MM200, MM200, SM200/MS200, M100/MS100.
After initial problems, the system is currently running, but there are apparently still opportunities for optimization
I'm currently using the EMS-ESP for monitoring and minor adjustments and I'm thrilled with it.
On site you can set the control times for hot water or night setback at the thermal bath.
I didn't discover this in the EMS-ESP, can you also activate this part of the control so that you can change it remotely?
kind regards
Christian
Beta Was this translation helpful? Give feedback.
All reactions