Skip to content

Latest commit

 

History

History
81 lines (60 loc) · 2.71 KB

INSTALL.md

File metadata and controls

81 lines (60 loc) · 2.71 KB
Raw

Installation instructions

Black Magic Probe firmware installation instructions for STM32F103 Blue Pill and STM32F401/STM32F411 Black Pill follow.

Installation on STM32F103 blue pill

Download and extract the latest blackmagic-firmware.zip from Releases. Connect a STM32F103 Blue Pill for serial upload:

  • Set boot jumpers for boot from rom: Boot0=1, Boot1=0.
  • Connect a USB-Serial adapter with A9 to RX, A10 to TX.
  • Press reset.
  • Upload the firmware: stm32flash -w blackmagic_allinone-bluepill.bin /dev/ttyUSB0 with /dev/ttyUSB0 the USB-serial adapter
  • After upload, set boot jumpers for boot from flash: Boot0=0, Boot1=0.
  • Remove usb-serial adapter
  • Connect to usb.

Pinout on STM32F103 blue pill

Signal Pin
SWDIO B14
SWCLK A5

Installation on STM32F401/STM32F411 black pill

Download and extract the latest blackmagic-firmware.zip from Releases.

Windows

Connect a STM32F401 or STM32F411 Black Pill for upload:

  • Download dfu-util
  • Connect the Black Pill to usb. Make sure it's a data cable, not a charging cable.
  • Push NRST and BOOT0
  • Wait a few seconds
  • Release NRST
  • Wait a few seconds
  • Release BOOT0
  • Upload the firmware: ./dfu-util -a 0 --dfuse-address 0x08000000:leave -R -D blackmagic-blackpillv2.bin
  • If dfu-util gives the error Cannot open DFU device xxxx:xxxx download zadig, select "STM32 Bootloader", install the WinUSB driver and run dfu-util again.
  • Disconnect and reconnect to usb

Linux

Connect a STM32F401 or STM32F411 Black Pill for upload:

  • Install dfu-util. On Debian/Ubuntu, type sudo apt-get install dfu-util
  • Connect the Black Pill to usb. Make sure it's a data cable, not a charging cable.
  • Push NRST and BOOT0
  • Wait a few seconds
  • Release NRST
  • Wait a few seconds
  • Release BOOT0
  • Upload the firmware: dfu-util -a 0 --dfuse-address 0x08000000:leave -R -D blackmagic-blackpillv2.bin
  • If dfu-util does not find the black pill, execute dfu-util as root.
  • Install udev rules
  • Disconnect and reconnect to usb

I am using this blackpill board: STM32F411 with 8MB flash.

Pinout on STM32F401/STM32F411 black pill

Pinout:

Signal Pin
SWDIO B9
SWCLK B8

Pinout on release v1.9.x and earlier:

Signal Pin
SWDIO A13
SWCLK A14

Installation on other platforms

Open the source tree, go to the subdirectory for your platform and check the "readme" for installation instructions. The exact pinout used is in the file "platform.h".