Skip to content

External ADC

Jump to bottom
Phil Schatzmann edited this page Mar 24, 2022 · 35 revisions

Here is a list of the most frequent devices which can be used as I2S source by the framework. When you have a new device I recommend to start with the streams-i2s-csv sketch so that you can verify the data that you receive. A typical 2 channel int16_t audio signal might look as this:

Signal

INMP441 Mems Microphone

INMP441

The INMP441 is a high-performance, low power, digital-output, omnidirectional MEMS microphone with a bottom port. The complete INMP441 solution consists of a MEMS sensor, signal conditioning, an analog-to-digital converter, anti-aliasing filters, power management, and an industry-standard 24-bit I²S interface. The I²S interface allows the INMP441 to connect directly to digital processors, such as DSPs and microcontrollers, without the need for an audio codec in the system.

Pins

INMP441 ESP32
VDD 3.3
GND GND
SD IN (GPIO32)
L/R GND
WS WS (GPIO15)
SCK BCK (GPIO14)
  • SCK: Serial data clock for I²S interface
  • WS: Select serial data words for the I²S interface
  • L/R: Left / right channel selection When set to low, the microphone emits signals on one channel of the I²S frame. When the high level is set, the microphone will send signals on the other channel.
  • SD: Serial data output of the I²S interface
  • VCC: input power 1.8V to 3.3V
  • GND: Power groundHigh
I2SStream i2sStream;
auto cfg = i2sStream.defaultConfig(RX_MODE);
cfg.i2s_format = I2S_STD_FORMAT; // optional because default setting
cfg.bits_per_sample = 32;
cfg.channels = 2; // optional because default setting
cfg.sample_rate = 44100;
cfg.is_master = true; // optional because default setting
i2sStream.begin(cfg);

The sample_rate is just a proposal and you can adjust it to your needs. Please note that the data is provided only on one channel as int32_t!

'I2S ADC Audio I2S Capture Card Module'

Usually you do not need any master clock, but unfortunately we need to feed this module with a master clock signal from the ESP32, if the ESP32 is acting as master.

Pins

i2s-adc

i2s-ADC ESP32
MCCLK_IN RX_0 (GPIO3)
BICK BCK (GPIO14)
DATA IN (GPIO32)
RLCLK WS (GPIO15)
GND GND
MUTE -
VCC VIN 5V 
I2SStream i2sStream;
auto cfg = i2sStream.defaultConfig(RX_MODE);
cfg.i2s_format = I2S_STD_FORMAT; // or try with I2S_LSB_FORMAT
cfg.bits_per_sample = 32;
cfg.channels = 2; // optional because default setting
cfg.sample_rate = 44100;
cfg.is_master = true; // optional because default setting
// this module needs a master clock if the ESP32 is master
cfg.use_apll = false;  
cfg.pin_mck = 3; 
i2sStream.begin(cfg);

The sample_rate is just a proposal and you can adjust it to your needs. Please note that the data is provided on both channels as int32_t!

Clone this wiki locally