Had warning to adjust baud rate, now lights don't work properly.

[klassi]

I set up my zones, had the lights hooked up and just needed to adjust colors, but I had a warning on the bottom that my baud rate was too low for the fps I had set (60).

I went to the configuration wizard, adjusted the baud rate, and now the lights only flash like normal on Prismatik startup, but do not work with screen grabbing or anything else. I tried uninstalling and reinstalling, restarting the computer, and resetting the baud rate. Nothing works.

Any help?

[zomfg]

your board has to be able to communicate at the baudrate you set

[klassi]

your board has to be able to communicate at the baudrate you set

Even when I set it back to the original baudrate, the lights still aren't working with the software after the initializing