fw_printenv example.txt

baudrate=115200
ipaddr=192.168.1.1
serverip=192.168.1.33
uboot_env_ver=1.5
img_prefix=emg2926aavk-
loadaddr=80400000
readonly=ro
setmtdparts=setenv mtdparts mtdparts=spi0.0:${ldr_psize}(u-boot)${readonly},${env_psize}(env)${readonly},${rfdat_psize}(RFdata)${readonly},-(nbu)\;ath79-nand:${rfsdat_psize}(rootfs_data),${romd_psize}(romd),${hdr_psize}(header),${rfs_psize}(rootfs),${hdr1_psize}(header1),${rfs1_psize}(rootfs1),${bu1_psize}(bu1),-(bu2)
flashargs=setenv bootargs board=AAVK-EMG2926Q10A root=${bootmtd} rootfstype=jffs2 noinitrd ${bootmode} ${zld_ver}
addtty=setenv bootargs ${bootargs} console=ttyS0,${baudrate}
addmtd=setenv bootargs ${bootargs} ${mtdparts}
boot_flash=run setmtdparts flashargs addtty addmtd;fsload ${loadaddr} /boot/vmlinux.lzma.uImage;bootm ${loadaddr}
bootcmd=run boot_flash
ldr_paddr=0x9f000000
ldr_psize=0x40000
env_paddr=0x9f040000
env_psize=0x10000
rfdat_paddr=0x9f050000
rfdat_psize=0x10000
rfsdat_paddr=0
rfsdat_psize=0x200000
romd_paddr=0x200000
romd_psize=0x200000
hdr_paddr=0x400000
hdr_psize=0x100000
rfs_paddr=0x500000
rfs_psize=0x1E00000
hdr1_paddr=0x2300000
hdr1_psize=0x100000
rfs1_paddr=0x2400000
rfs1_psize=0x1E00000
bu1_paddr=0x4200000
bu1_psize=0x200000
lu=tftp ${loadaddr} ${dir}u-boot.bin;zflash erase ${ldr_paddr} ${ldr_psize};zflash write ${fileaddr} ${ldr_paddr} ${filesize}
lf=tftp ${loadaddr} ${dir}${img_prefix}rootfs.jffs2;nand erase ${rfs_paddr} ${rootfs_psize};nand write ${fileaddr} ${rfs_paddr} ${filesize}
hostname=AAVK-EMG2926Q10A
countrycode=FF
ethaddr=5C:6A:80:##:##:##	changed this but will be your WAN typically
serialnum=S###A########		changes this