ACIDS 2022 NIME Workshop #3

---

Overview

This guide will help you setup everything you need for the ACIDS 2022 NIME Workshop #3

Requirements

• Computer (All OSes should work)
• Raspberry Pi 4 (3b+ is possible but will probably lag a bit)
• Ethernet cable (Wifi is possible, but you'll need to connect manually)

Install Raspberry Pi OS Lite 64bits

Direct Download Link (from the Raspberrypi's website)

(If you're using a RaspberryPi 3 download the 32bits version)

Flash the OS onto your microSD card

Raspberry Pi Imager is the quick and easy way to install an operating system to a microSD card ready to use with your Raspberry Pi.

• Insert your microSD card in your computer
• Open Raspberry Pi Imager, click on "Choose OS" then "Use a Custom Image" and select the iso you just downloaded.
• Select the microSD as the target destination
• Launch the write process

Enable ssh to allow remote login

For security reasons, ssh is no longer enabled by default. To enable it you need to create an empty file named ssh (no extension) in the root of the boot disk (the microSD you just flashed)

WIFI only: add your network info

Create a file in the root of boot called: wpa_supplicant.conf then paste

country=US
ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev
update_config=1

network={
    ssid="NETWORK-NAME"
    psk="NETWORK-PASSWORD"
}

(adjusting for your ISO 3166 alpha-2 country code, network name and network password)

Ethernet

Just connect your RaspberryPi to your router using an ethernet cable

Get your RaspberryPi ip adress

either:

• connect your rapsberrypi to a monitor & a keyboard, open a terminal and type ifconfig
• check your modem admin panel for connected equipements
• scan your network with sudo nmap -sn 192.168.1.0/24 (will probably not work on complex networks like those used in companies, universities etc...)

Connect using SSH

from your computer: ssh pi@{IP_ADDRESS}

sudo apt-get update -y
sudo apt-get install git pip libportaudio2 libsndfile1 -y

git clone https://github.com/dgenova/RAVEberry-server.git
pip install -r requirements.txt