Skip to content

Generic CAN Bridge emulating FRC netcomm CAN driver for connecting a PC to the CAN Bus with WPILib 2020+ and SPARK MAX (FW 1.5.0 or higher) or other drivers, currently only supported in Windows.

License

Notifications You must be signed in to change notification settings

REVrobotics/CANBridge

Repository files navigation

CANBridge

Overview

This repository is for the CANBridge software that is run on non-roboRIO platforms.

Behavior

When sending a frame with a given interval, the behavior when setting a new interval is as follows:

The first time a frame is scheduled with an interval, it will be sent at the next available time. The next instance of the same frame id will be sent after that interval, even if the interval has changed.

See the following pseudo-example:

sendMessage(frame, 5000)
delay(1000)

updateFrameData(frame)
sendMessage(frame, 1000)
delay(500)

updateFrameData(frame)
sendMessage(frame, 2000)

In this case, the first frame will be scheduled immediately, the second will be scheduled 5 seconds later, and after that, subsequent frames will be scheduled every 2 seconds. Note that any change to the data in the second call will not be sent, meaning the second call is essentially a no-op if a new call with different data is sent before the previous interval is up. Sending a frame with an interval of -1 will cancel the repeat, and not send the frame. Sending with an interval of 0 will schedule the new frame once, then stop repeating. Unlike with a positive interval, an interval of 0 guarantees that each new message will be sent.

Build Requirements

  1. Git
  2. Visual Studio Code or some other equivalent IDE
  3. Gradle Build Tool
  4. Java JDK/JRE

All of these, excluding Git, can be installed and configured with the WPILib Installer, which will include specific versions for building FRC robot code. Gradle needs a C++ compiler, which is included with VS Code.

Building and Publishing

Building is done using the Gradle wrapper, gradlew. The Gradle wrapper is located in the root of the project, so Gradle commands must be run from there.

  1. Clone this repository and open in VS Code
    • When VS Code first opens, select Add workspace folder... underneath Start on the Welcome Screen
  2. Open the VS Code terminal
    • View -> Terminal or Ctrl+`
  3. Run ./gradlew build from root

The output is placed at ~\releases\maven\release\com\revrobotics\usb\CANBridge-cpp\<version>\.

Publishing a new version

Before publishing a new version, run ./gradlew build locally to run the tests. GitHub Actions cannot run the tests because they depend on having a USB CAN device connected.

  1. Bump the version number in publish.gradle and CANBridge.json
  2. Commit the version bump
  3. Create a new tag named vX.X.X at that commit
  4. Push the tag to GitHub
  5. Wait for the draft release to be created
  6. Add release notes to the draft release
  7. Publish the draft release

Changelog

The SDK Changelog can be viewed with Changelog.md.

About

Generic CAN Bridge emulating FRC netcomm CAN driver for connecting a PC to the CAN Bus with WPILib 2020+ and SPARK MAX (FW 1.5.0 or higher) or other drivers, currently only supported in Windows.

Resources

License

Stars

Watchers

Forks

Packages

No packages published