Home

Welcome to the betrusted-hardware wiki!

For lack of a better place, here is the DVT hardware validation tracker.

• on power, no tuning, board 2_L as measured at battery - 595mW (wifi off), 626mW (wifi scanning)
• standby, no tuning, board 2_L as measured at battery - 4.3mA @ 4.2V = 18mW (wifi off), 12mA @ 4.2V = 50mW (wifi scanning)
• ship mode, no tuning, board 2_L as measured at battery - 0.07mA-0.03mA (50/50 duty) @ 4.2V. Probably gas gauge.
• backlight (keyboard strand) - +134mA at 4.15V = 0.556 watts 100% brightness

Quick Test

• SRAM: OK
• SPINOR: OK
• KEYBOARD: OK
• TRNG_AVALANCHE: OK
• TRNG_OSC: OK
• I2C: OK
• RTC: OK
• RTC_ALARM: OK
• AUDIO: OK; note: firmware unstable after soft-boots
• SPEAKER: OK
• VIBE: OK
• JTAG_LOOP: Ok
• MEMLCD: OK
• COM: OK
• REBOOT: OK
• WIFI: OK
• CHARGER: OK
• GASGAUGE: OK
• SLEEP_POWER: OK
• SLEEP_WAKE: OK
• KEYBOARD_WAKE_COMBO: OK - consider introducing 100k pull-downs on sense lines
• SHIPMODE: OK - requires ECO
• SRAM_SLEEP_RETENTION: OK
• EC_SPI: OK
• EC_UART: OK
• SOC_JTAG: OK
• SOC_UART: OK
• GYRO: OK (but interrupts not tested)
• BACKLIGHT: (kbd OK LCD pending)
• USB_BOOST: FAIL - needs work-around PCB for switchover network
• USB_DEVICE: OK - works as wishbone target
• USB_HOST:
• CHARGER_DETECT: OK
• VBUS_LEVEL: OK
• T_DISCHARGE: OK
• ANTIGLITCH: OK
• XADC: OK
• BITSTREAM_INJECT: needs drivers, defer

Full test

• All TBD