Bluetooth Slave JDY-31 SPP (Serial Port Profile) Task Handler C Driver

• version 1.0
• Reza Ebrahimi

This library is written in portable C, and is MCU independent. JDY-31 is a bluetooth V4.0 SPP slave module. In order to implement it to your MCU of choice, you need to manipulate functions inside jdy_slave.h, jdy_slave_low_level.c and jdy_slave_tasks.c.

An arbitrary number of tasks could be defined by user (256 tasks maximum, theoretically).

Any resemblance to pre-existing code is unintentional.

GENERAL INFORMATION

JDY-31 SPP bluetooth module, otherwise known as SPP-C, is a bluetooth slave module based on BK3231S Bluetooth SoC by Beken. It supports a total of 8 AT Commands:

AT+VERSION

AT+RESET

AT+DISC

AT+LADDR

AT+PIN

AT+BAUD

AT+NAME

AT+DEFAULT

HOW TO USE

After configuring low level functions inside jdy_slave_low_level, you need to add your predefined tasks and their names into the case-switch statement inside jdy_slave_tasks.c. Next, add the task names inside the 'enum tasks', and NUMBER_OF_TASKS inside jdy_slave.h. Inside your own firmware, use bluetooth_slave_init() to start communicating with SPP module, and bluetooth_tasks_handler() to check for incoming tasks.

C FUNCTIONS

Functions can be categorized in different levels. Higher level functions use Lower level functions.

LEVEL 1:

• void bluetooth_uart_set (uint32_t baud_rate)
• uint8_t bluetooth_buffer_status ()
• void bluetooth_buffer_read (uint8_t *input_string, uint8_t string_length)
• void bluetooth_send_byte (uint8_t input_byte)
• void delay_function (uint32_t delay_ms)

LEVEL 2:

• void bluetooth_command (uint8_t command)
• void bluetooth_buffer_flush()
• void bluetooth_receive_string (uint8_t *input_string, uint8_t string_length)
• void bluetooth_send_string (uint8_t *output_string, uint8_t string_length)
• void task_switcher(uint8_t index)
• static void string_eraser (uint8_t *input_string, uint8_t string_length)

LEVEL 3:

• void bluetooth_tasks_handler()
• void bluetooth_slave_init()