Adds one or two settings, $536 and $537, for setting number of LEDs in NeoPixel/WS2812 LED strips.
Dependencies:
Driver and board support for LED strips.
Configuration:
Add/uncomment #define RGB_LED_ENABLE 1 in my_machine.h.
Adds support for Marlin style M150 command.
M150 [B<intensity>] [I<pixel>] [K] [P<intensity>] [R<intensity>] [S<strip>] [U<intensity>] [W<intensity>]
B<intensity> - blue component, 0 - 255.
I<pixel> - LED index, 0 - 255. Available if number of LEDs in strip is > 1.
K - keep unspecified values.
P<intensity> - brightness, 0 - 255.
S<strip> - strip index, 0 or 1. Default is 0.
R<intensity> - red component, 0 - 255.
U<intensity> - red component, 0 - 255.
Dependencies:
Driver and board support for LED strips.
Configuration:
Add/uncomment #define RGB_LED_ENABLE in my_machine.h and set/change the define value to 2.
Dependencies:
Driver and board support for LED strips.
Note
If B axis is enabled then the plugin will not be activated.
Configuration:
Add/uncomment #define EVENTOUT_ENABLE 1 in my_machine.h .
Depending on the number of free output ports up to four events can be selected.
Settings $750+<n> is used to select the event (trigger) to bind to the port selected by setting $760+<n>
where <n> is the event number, currently 0 - 3.
Dependencies:
The selected driver/board must provide at least one free auxillary output port.
Credits:
Based on idea from plugin by @Sienci-Labs.
*** Experimental ***
Adds support for Marlin style M280 command.
M280 [P<index>] [S<position>]
P<index> - servo to set or get position for. Default is 0.
S<position> - set position in degrees, 0 - 180.
If omitted the current position is reported:
[Servo <index> position: <position> degrees]
Configuration:
Add/uncomment #define PWM_SERVO_ENABLE 1 in my_machine.h.
Dependencies:
The selected driver/board must provide at least one free auxillary analog output port that is PWM capable.
Credits:
Based on code by @wakass.
*** Experimental ***
Adds support for Marlin style M401 and M402 commands.
M401 [H] [R<0|1>] [S<0|1>] - deploy probe
H - report high speed mode.
R<0|1> - currently ignored.
S<0|1> - S0: disable high speed mode, S1: enable high speed mode.
M402 [R<0|1>] - stow probe
R<0|1> - currently ignored.
Configuration:
Add/uncomment #define PWM_SERVO_ENABLE 1 and #define BLTOUCH_ENABLE 1 in my_machine.h.
Dependencies:
The selected driver/board must provide at least one free auxillary analog output port that is PWM capable.
Credits:
Based on code by @wakass.
2024-09-04