A two-zone model is simulated with MATLAB, and you can find Volume, Area, Velocity, Burn Fraction, Unburned/Burned Area/Mass/Temperature/Volume, Pressure, and Work here.
In Sec.1 some initial values such as Compression Ratio, density, etc are configured.
In Sec.2 Volume and Area are calculated.
Fig.1 –Each Cylinder Volume
Fig.2 – The Cylinder Area
In Sec.3 The velocity is calculated.
Fig.3 – The Velocity
In Sec.4 The burn Fraction is calculated.
Fig.4 – The Burn Fraction
In Sec.5 The main calculation is done.
Fig.5 – The Unburned/Burned Area
Fig.6 – The Unburned/Burned Mass
Fig.7 – The Unburned/Burned Temperature
Fig.8 – The Unburned/Burned Volume
Fig.9 – The Motoring Pressure
Fig.10 – The Pressure
Fig.11 – The Work
In Sec.6 & 7 figures are configured.