Remeshing: Tree/roots wireframe

Table of contents

• Introduction
• Results
• Installing, configuring and running

Introduction

The goal of this project is to create a remeshing algorithm which would transform a mesh into a tree/root like structure. The final goal is actually to 3d print the resulting mesh and use it as a lamp.

The final report can be found in the report.pdf file.

Results

final_mesh.obj contains the final mesh of our project, which is ready to 3d print.

This first image, shows the original mesh with the resulting mesh supperposed on it.

A simulation of the resulting mesh with a light source in the middle (as a lamp would).

A video showing the gui, the generating process, and a simulation of the final mesh used as a lamp.

Installation configuration running

All the necessary information for this project can be found in the report.pdf file.

Instructions to run it can be found in the "Instructions" chapter of the report.pdf file.