Refer to the build guide for direction on producing the PCB and the README for installation information.
Changes (v0.5.1)
Note: No changes are made to any Gerbers from v0.5.
- Fixed a bug in the XGMDriver installer which inverted the decision between AMD and NVIDIA. This caused device unplug to not work correctly.
- (Standard) Added standby support. GPU will be powered off completely when host is powered off.
- Cable LED light now follows the same pattern as the official XGM: white = cable connected and host powered on, red = PCIe lanes connected
- Fixed an issue where shutting down may take a long time due to a missing I2C response
Changes (v0.5)
- Added Lite board
- Replaced XGMActivator with XGMDriver which should be more reliable
- (Standard) Added SPI flash for USB hub to allow firmware updates
- (Standard) Changed min drill size to 0.3mm to reduce cost
- (Standard) Moved some decoupling capacitors to bottom layer
- (Standard) Replaced male power passthrough with a female connector
- (Standard) Changed charging limit from 100W to 65W to give more power to the GPU (65W is the minimum that allows Ally to still turbo at 30W)