Cluster creation

This guide is for PlotSquared versions <= 1.12.2

The following in a excerpt from the Augmented plotworld installation guide. If you would like a partial plotworld rather than a full plot world, please see the guide

*Please enable clusters on your PlotSquared config.

Step 3: Creating a cluster

Cluster creation can be somewhat tricky to understand the first time. The clusters work by a co-ordinate system much like a normal plotworld, and each cluster will be created between two points in this co-ordinate system.

Please login and travel to your new cluster world. The following command will be used to create a cluster: /plot cluster create <name> <plot id 1> <plot id 2>

name: what you want to call the cluster

plot id 1: Is the first co-ordinate and must be smaller than plot id 2 The id comes in the form X;Z e.g. 5;3

To calculate what the plot id would be for a location use the following formula: big X' and Z' represents the plot X and Z value respectively small x and z represents the minecraft x and z value respectively

`X' = 1 + (x / <plot_width + road_width>)`
`Z' = 1 + (z / <plot_width + road_width>)`

• You can find your plot width and road width within the worlds.yml

Notes

Just entering /plot cluster create will display an estimate for your current plot id.